5.Place a flat washer (E2) on each barrel bolt (E3), and insert the bolts through the right- side leg (Figure 12).
6.Using a 5mm hex wrench, thread the bolts into the barrel nuts (E4) (Figure 12), but do not fully tighten at this time.
7.Insert the lower panel (F) into the slots of the two lower cross braces (E), and into the groove of the side leg (Figure 13).
| C |
| E |
F | E |
Figure 13. Lower panel installation.
8.Insert both central drawer support panels (H) (Figure 14) into the cross brace (E) slots.
HC
F
E
Figure 14. Drawer support installation.
9.Install the two upper cross braces (D) (Figure 15) into leg (C) the with the same hardware and methods covered in Steps 1-7. Do not fully tighten the hardware yet.
|
| C |
D | F | E3 |
| ||
| E2 | |
|
| |
| D |
|
Figure 15. Upper cross panel installation.
10.Insert the upper panel (F) into the slot of the two upper cross braces (D) and into the groove of the side leg (Figure 15).
11.Insert the remaining four barrel nuts (E4) (Figure 16) into the other end of the previ- ously installed cross braces.
Make sure that the slotted end of the barrel nuts face outward and the screwdriver slots are aligned horizontally with the direction of the cross braces.
12.Position the left side leg (B) on the floor so the UP arrow is pointing upward and the FRONT arrow points to the front as shown in
Figure 16.
E4 |
B |
E2 |
E3 |
Up |
E4 |
Front |
