Dust Collection
DO NOT operate the Model H8145 without an adequate dust collection system. This saw creates substantial amounts of wood dust while operating. Failure to use a dust collec- tion system can result in short and
To connect a dust collection hose:
1.Fit a 11⁄2" dust hose over the dust port, as shown in Figure 4, and secure in place with a hose clamp.
2.Tug the hose to make sure it does not come off. Note: A tight fit is necessary for proper performance.
3.Connect the dust hose to a shop vacuum or dust collector.
Figure 4. Dust hose attached to dust port.
Test Run
The test run consists of verifying that the motor runs correctly and that the safety disabling key on the switch works correctly.
If, during the test run, you cannot easily locate the source of an unusual noise or vibration, immedi- ately disconnect the machine from power, then review Troubleshooting on Page 22 or contact our Tech Support at (570)
To test run the machine:
1.Make sure you have read through the entire manual, you are familiar with the controls of the machine, and you have completed the setup section.
2.Clear all items (tools, parts, etc.) away from the machine.
3.Connect the machine to the power source.
4.Turn the machine ON.
5.Turn the machine OFF.
6.Remove the switch disabling key, as shown in Figure 5.
