Grizzly H8145 Blade Tilt/Bevel Cuts, Changing Blade, To tilt the blade, Tools Needed Qty

Blade Tilt/Bevel Cuts

The blade can tilt from 0° to 45° to make beveled cuts. Beveled cuts are made in the same manner as rip cuts.

To tilt the blade:

1.DISCONNECT SAW FROM POWER!

2.Loosen the lock handles at the front and back of the machine.

Note: The lock handles have a ratcheting action. Disengage them by pulling back on the handle. When held back (disengaged), the handles will rotate in either direction with- out turning the threads. When you let go of the handles, the internal spring will automati- cally engage them again so the threads turn with the handles.

3.Tilt the motor/blade assembly until the pointer shown in Figure 16 points to the desired blade tilt angle.

Pointer

Tilt Scale

Figure 16. Tilt scale and pointer.

4.Tighten the front and rear lock handles to lock the blade in place.

H8145 Baby Table Saw

	Changing Blade
Tools Needed		Qty
•	Arbor Wrench 19mm	1
•	Arbor Wrench 8mm	1
•	Phillips Screwdriver #2	1

To change the blade:

1.DISCONNECT SAW FROM POWER!

2.Remove the two screws shown in Figure 17, then remove the blade cover.

Figure 17. Blade cover screws.

3.Hold the blade arbor with the small arbor wrench, then use the large arbor wrench to remove the arbor hex nut, as shown in Figure 18.

Blade Flange

Figure 18. Wrench positions to remove arbor

hex nut.

4.Remove the old blade and reinstall the new blade, making sure that the blade flanges get reinstalled on both sides of the blade.

5.Replace and tighten the arbor hex nut, then re-install the blade cover.

-19-