Inventory

After all the parts have been removed from the shipping box you should have the following items:

Box Contents (Figure 4):

Qty

A.

Log Splitter Body

1

B.

Support Leg

1

C. Hardware Bag (Not Shown)

1

 

— Carriage Bolts M8-1.25 x 10

5

 

— Hex Nuts M8-1.25

5

A

B

Figure 4. H8170/H8171 Inventory.

If any nonproprietary parts are missing (e.g. a nut or a washer), we will gladly replace them; or for the sake of expediency, replacements can be obtained at your local hardware store.

NOTICE

Some hardware/fasteners on the inventory list may arrive pre-installed. Check mount- ing locations before assuming that any items from the inventory list are missing.

-10-

Site Considerations

Work Surface

Always use the splitter on a flat, stable work sur- face. Operating your splitter will be easiest when the controls are waist high. At minimum, your work surface must safely support the combined weight of splitter and the heaviest log you intend to split.

Working Clearances

Allow enough room on all sides to move logs to and from the splitter. Refer to the Machine Data Sheet for the dimensions of your splitter.

Moving the Splitter

The wheels on the Model H8170/H8171 make it possible for one person to move it short distances. However, the rugged design of your splitter makes it heavy; we recommend that you get assistance whenever lifting it.

To move the splitter :

1. DISCONNECT THE LOG SPLITTER FROM THE POWER SUPPLY!

2. Close the air bleeder screw by turning it clockwise (viewed from the rear of the split- ter) until it stops. This will prevent hydraulic fluid from leaking out during the move.

3. Grab the front handle and lift until the wheels carry the load of the rear end. You will need to raise the front end about 15" to shift the load to the wheels. Roll the splitter to the desired location and lower the front end.

4. Open the air bleeder screw by turning it clockwise two full turns.

To lift the splitter:

1. Do Steps 1–2, above.

2.Get an assistant to help you to lift the split- ter and carry it to the new worksite; use the handles at each end.

H8170/H8171 Hydraulic/Electric Log Splitter

Page 12
Image 12
Grizzly H8170 Inventory, Site Considerations, Box Contents Figure Qty, To move the splitter, To lift the splitter