Spray Gun Lock |
| Starting |
|
|
|
|
|
|
The spray gun has a lockout lever that can be engaged to prevent accidental discharge. This feature is especially useful when climbing up a ladder or doing any work that might accidentally discharge the spray gun. To engage the lockout lever, simply flip it away from the trigger and clip it into the lockout lever groove in the handle (Figure 10). To release the lever, reverse this procedure (Figure 11).
Figure 10. The spray gun in the locked position.
Figure 11. The spray gun in the unlocked
position.
Operation of this equipment has the potential to propel debris into the air which can cause eye injury. Always wear safety glasses or goggles when operating equipment. Everyday glasses or reading glasses only have impact resistant lenses, they are not safety glasses. Be certain the safety glasses you wear meet the appropriate standards of the American National Standards Institute (ANSI).
To start the H8189/H8190 pressure washer:
1.Check the engine and pump oil level and fuel level (refer to the MAINTENANCE section beginning on Page 16 for locations). Add engine oil (SAE 30) and/or fuel (unleaded gasoline) if necessary.
2.Securely fasten one end of the provided input hose to a threaded hose spigot. Securely fasten the other end of the input hose to the pump input port.
Note: When drawing water from a standing source, follow the standing source instructions on Page 15. When drawing water from a spigot, you may need to use the provided
3.Make sure the spray gun is securely connected to the high pressure hose, and that the high pressure hose is securely connected to the pump output port.
4.Attach the appropriate nozzle to the quick coupler at the end of the spray gun wand, and turn on the water supply at the spigot.
NOTICE
Never allow the motor to run without a water source connected to the pump. Failure to follow this instruction will damage the pump and void the warranty.
H8189/H8190 Gasoline Pressure Washer |
