Grizzly H8209 instruction manual Impact Wrench, Tire Inflator, Blow Gun, Daily Maintenance

EYE INJURY

HAZARD!

Wear protective equipment when using these tools.

Impact Wrench

Your new single hammer 1⁄2" drive impact wrench (Figure 2) will generate up to 230 ft/lbs. of torque.

Only use thick-walled impact sockets with this air tool. The common thin-walled chrome sockets may explode if used as impact sockets causing serious injury.

At the end of the handle you can adjust the torque setting by pushing the knob in and turning the knob to 1, 2, 3, or 4; 1 is the lowest torque setting.

To change the impact rotation, push the slide button toward the front of the gun for clockwise rotation and to the rear for counterclockwise rotation.

Rotation Button

Torque Setting

Figure 4. Impact wrench locations.

Tire Inflator

1.Connect the air hose to the tire infla- tor.

2.Connect inflator to the tire air valve.

Model H8209 14-Piece Air Tool Kit

3.Pull the trigger until the appropriate air pressure is reached.

4.If the pressure in the tire is too high, push the pressure release valve to bleed the excess pressure.

Pressure Gauge

Release Valve

Inflator

Figure 5. Tire inflator locations.

Blow Gun

1.Attach the blow gun to the air supply with the air hose.

2.Aim the blow gun at the workpiece and pull the trigger. DO NOT point the blow gun in the direction of yourself or oth- ers.

Daily Maintenance

Your impact wrench MUST have 2-6 drops of oil directly dropped into the air fitting before each use. In addition, we recommend using an in-line filter, lubricator, and regulator, as shown in Figure 2. If an in-line lubricator is not used, add 2-3 drops of oil into the tool air inlet every 2 hours of continued use.

These procedures should be done after each use:

•Before putting the impact wrench away, put 2-6 drops of oil into the air supply fitting and momentarily operate the impact wrench to distribute the oil inside the tool.

•Wipe the tool exterior and sockets with a slightly oiled cloth. Your goal is to leave a light film of oil on the tools to

prevent rust. -5-