OPERATIONS
Read the manual before operation. Become familiar with this tool, its safety instructions, and its operation before beginning any work. Serious personal injury may result if safety or operational information is not understood or followed.
DO NOT use bits or cutters with a cutting diameter larger than 1". The bit or cutter could break apart under the stresses of high speed use, causing serious personal injury.
Installing Bits
The Model H8213 uses bits and cutters with a 1/4" and 1/8" diameter shaft. See the Grizzly catalog or www.grizzly.com for a complete listing of available bits and accessories.
To install a bit:
1.DISCONNECT THE GRINDER FROM THE AIR SUPPLY!
2.Use the two included wrenches to loos- en the collet nut, as shown in Figure 2.
Note: It is not necessary to com- pletely remove the collet nut from the shaft unless you are also changing the collet.
Like all tools there is potential danger when operating this tool. Accidents are frequently caused by lack of familiarity or failure to pay attention. If normal safety precautions are overlooked or ignored, serious personal injury may occur.
Figure 2. Loosening the collet.
3.Insert at least 1⁄2" of the bit into the collet.
4.Hand tighten the collet nut, then use the collet wrenches to fully tighten. Verify that the tooling bit is secure and will not pull out.
Model H8213 14 Piece Angle Die Grinder Kit |
