Grizzly H8213 instruction manual Using the Grinder, Daily Maintenance, To use the grinder

Using the Grinder

Always test the tooling bit on a scrap piece of material similar to the workpiece. Trial and error is the best way to determine the ideal setup.

To use the grinder:

1.Attach the 1/4" NPT male quick connect fitting to the air inlet plug.

2.Attach the grinder to an air supply set at 90 PSI.

3.Hold the grinder securely.

4.Turn the grinder ON by depressing the trigger.

5.Securely holding the grinder, ease the working end of the bit against the workpiece with a light, but steady, pres- sure.

6.To turn the grinder OFF, release the trigger.

7.To avoid accidental starting, discon- nect the grinder from the air supply when it is not in use.

Daily Maintenance

The die grinder MUST have 2-6 drops of oil directly dropped into the air fitting before each use. In addition, we recommend using an in-line filter, lubricator, and regulator, as shown in Figure 3.

Quick	Quick	Lubricator
Connector	Connector		Regulator
Your			Air
Tool			Compressor
Quick
Coupler		Quick
	Air Hose		Filter
		Coupler

Figure 3. Installed filter lubricator

regulator.

LUNG/EAR

INJURY HAZARD!

Wear protective

equipment when

using this tool.

ACCIDENTAL

START HAZARD!

Disconnect before

service or tool

changes.

AIR PRESSURE

HAZARD!

Never exceed max

PSI rating for tool.

EYE INJURY

HAZARD!

Wear protective

equipment when

using this tool.

The die grinder MUST also have 2-6 drops of gear lubricating oil directly dropped into the oil valve located in the angle housing, as shown in Figure 4.

Oil Valve

Figure 4. Oil valve location.

These procedures should be done after each use:

•Wipe the motor housing and tool bits with a dry cloth, or blow off the dust and debris with compressed air.

•Check for damage to tooling, hoses, housing or other accessories.

Model H8213 14 Piece Angle Die Grinder Kit -5-