Additional Safety Instructions for Nailers
1.HAND INJURIES: Do not place your hands near the nail point of entry. A nail can deflect and tear through the surface of the workpiece, puncturing your hand or fingers.
2.COMBUSTIBLE GASES: Never con- nect the nailer to pressurized oxy- gen or other combustible gases as a power source. Only use filtered, lubri- cated, and regulated compressed air.
3.SAFE HANDLING: Never point the nailer at others! Do not keep the trig- ger pulled when loading fasteners, carrying, or holding tool. Carry the nailer only by the handle, never by any other part. Do not carry the nailer by the air hose. Disconnect the nailer from the air hose when going up and down ladders.
4.MODIFICATIONS: DO NOT modify this tool or bypass the safety nose mechanism.
5.CHECK VALVE: Do not use a check valve or any other fitting that allows air to remain in the tool.
6.HOSE USAGE: Make sure your air hose is designed for the tool in use, is in good condition, and is long enough to reach your work without stretching. However, an overly long air hose in the work area may be a tripping haz- ard.
7.OPERATING QUESTIONS: If you are not sure about the intended oper- ation, stop using the nailer. Seek formal training.
8.CLEANING: Never use gasoline or other flammable liquids to clean the nailer; vapors in the nailer will ignite by a spark and cause it to explode.
9.MAINTENANCE: Always disconnect air from the nailer when servicing or installing nails. During maintenance, a nailer connected to air may fire acci- dentally, causing serious personal injury.
10.COMPRESSED AIR RATING: Do not connect the nailer to compressed air that exceeds 120 PSI.
Model H8235 |
