Compressed Air

System

The Model H8236 is designed to be oper- ated at the following air pressures using clean, dry, regulated, compressed air:

Tool

Operating Air Pressure

Brad Nailer

.............................. 60–100 PSI

Stapler

60–100 PSI

DO NOT exceed the 120 PSI maximum operating pressure for your nailer/sta- pler.

Before using your new nailer/stapler, regu- late the air pressure to find the optimum setting within the specified operating range. Start by testing the nailer/stapler at a low setting, then increase the air pres- sure as needed for satisfactory results.

An in-line filter/lubricator/regulator unit can be installed, as depicted in Figure 2.

This filter/lubricator/regulator unit will protect your tool from damaging water build-up, allow you to adjust and maintain constant air pressure to your tool, and save you the inconvenience of having to manually lubricate your tool every time you use it.

Exceeding the maximum permissible operating pressure may damage the nailer/stapler and cause it to malfunc- tion. To protect yourself from personal injury, DO NOT allow the air pressure to exceed the recommended pressure for these tools!

Check the current Grizzly catalog for avail- ability of this unit. If you plan on install- ing a filter/lubricator/regulator unit in your compressed air system, always follow the connection instructions that come with the unit.

Quick

Quick

Lubricator

Connector

Connector

Regulator

Your

 

 

Air

Tool

 

 

Compressor

Quick

 

 

 

Coupler

 

Quick

 

 

Air Hose

Filter

 

Coupler

 

 

Figure 2. Typical filter/lubricator/regulator installation order.

Model H8236 2-Piece Brad Nailer/Stapler Kit

-7-

Page 9
Image 9
Grizzly H8236 owner manual Compressed Air System, Tool Operating Air Pressure