SECTION 4: ASSEMBLY
Overview
Most of your G1033 Planer has been assembled at the factory, but some parts must be assembled or installed after delivery. We have organized the assembly process into steps. Please follow along in the order presented here.
TOOLS REQUIRED: Most of the tools required for assembly are included with the planer. However, you will also need a Phillips¨ and regu- lar screwdriver, metric wrenches, as well as a feeler gauge for adjustments.
Extension Rollers
The Model G1033 is supplied with extension rollers on both the infeed and outfeed ends of the table. The roller assemblies are identical for both infeed and outfeed. To attach the extension rollers:
1.Attach an extension bar to the end of each roller and secure with the 12mm snap rings provided.
2.The assembled extension rollers attach to the ends of the planerÕs table. Match the tapped holes on the side of the table to the extension bars and attach with the M10 x 1.5 Hex Bolts and washers provided. See
Figure 2.
3.Before final tightening, run a straight edge across the table and past each roller. Position the rollers flush with the table and tighten the Hex Bolts securely.
Extension
Mounting Bolts
Figure 2. Extension roller attachment.
Hand Wheel
The hand wheel operates the chain driven sys- tem which raises and lowers the table to control cutting depth. To attach the hand wheel:
1.Place the handwheel on the worm gear shaft and secure with hex nut and washer provided. See Figure 3.
2.Attach the handle to the handwheel and tighten hex nut.
Figure 3. Attaching handwheel.
|
|
|
|
|
|
|
|
G1033 20" Planer |
| ||
| |||
