Water Reservoir
The Model T10010 Wet Grinder is designed for wet grinding and should never be used without water.
Before filling the water reservoir, identify the high and low reservoir mounting slots. These slots allow the reservoir to be raised during grinding and lowered when not in use.
The mounting tabs on the reservoir serve as hooks to attach to the reservoir mount- ing slots (Figure 8).
Mounting | Upper Slot |
Tab | (Grinding) |
| Lower Slot |
| (Storage) |
Figure 8. Reservoir mounting positions.
NOTICE DO NOT attempt to use the grinding wheel without filling the reservoir with water. Overheating caused by lack of lubrication could damage the grinding wheel, as well as the tool or blade you are grinding. Ensure that the reservoir is filled with clean water.
To fill and position the reservoir:
1.Make sure the grinder is disconnected from power and that the grinding wheel is not rotating.
2.Remove reservoir and fill with water to just below the
3.Attach the reservoir to the grinder.
—If the grinder is going to be used immediately, position the reservoir in the grinding position by attaching it in the upper slot (Figure 9).
—If the grinder is not going to be used immediately, position the reservoir in the storage position by attaching it in the lower slot (Figure 10).
Note: Placing the reservoir in the stor- age position prevents damage to the wheel and potential hazards from being stored in water.
Figure 9. Grinding position.
Figure 10. Storage position.
Model T10010 Wet Grinder |
