Grizzly T10157 manual Attaching drawer slides to the drawers Align These Slides

2.Align the drawer side panels with the drawer sub-assembly, as shown in Figure 2, then secure them with the M4 x 30 wood screws.

3.Attach the ball bearing drawer slides to tops of the drawer side panels, as shown in Figure 3, with the M4 x 13 wood screws.

Note: Make sure the drawer slides properly fit with the pre-installed slides underneath the workbench top, as shown in Figure 4.

	M4 x 13
Drawer	Wood
	Screws
Slides

Figure 3. Attaching drawer slides to the drawers.

Align These Slides

Figure 4. Aligning the drawer slides with the pre-

installed slides.

NOTICE

When gluing parts together, wipe off the excess and allow the glue to completely dry before proceeding to avoid inadver- tently gluing the wrong parts in subsequent steps.

-2-

4.Insert the tubes through the rear of the vise leadscrew assemblies and secure them with the 5⁄16"-18 hex nuts and 5⁄16" flat washers, as shown in Figure 5.

1⁄4" x 1 1⁄2"	5⁄16" Hex Nut
Wood Screw	& Flat Washer
Tube
	Handle
	& Knob
Vise Face

Figure 5. Vise assembly.

5.Insert the handles through the ends of the vise leadscrew assemblies (see Figure 5) and glue on the knobs to hold them in place.

6.Slide the vise leadscrew assemblies into the vise faces and secure them with the 1⁄4" x 1 1⁄2" wood screws.

7.Position the vise leadscrew plates under- neath the table and align their holes with those in the table edges, then secure them in place with the 1⁄4" x 1 1⁄2" wood screws, as shown in Figure 6.

Vise
Leadscrew	1⁄4" x 1 1⁄2"
Plate

Wood Screw

Figure 6. Vise leadscrew plate aligned with the underside of table and holes in the table edge.

T10157 Oak Workbench