2.5.2Auto-Scroll Function
The
For
2.5.3Request and Error Messages
Note: When EEPROM errors occur or initializing the EEPROM is required, contact an authorized distributor/dealer.
Request and Status Messages
Display messages require the user to enter additional data, confirm the previous entry or require time to process as described below.
Entry Accepted appears for several seconds after pressing the Enter key during the programming mode. The display then shows the new data.
Initialize EEPROM? Prompt to confirm EEPROM initialization.
Reset Complete indicates the user has successfully:
DReset the maintenance records or
DRestored the AC analog inputs to the default settings.
DRestored voltage regulator settings to the defaults.
Right Arrow → directs the user to the next menu. The menus loop; press the right arrow key to move to the next menu.
Setup Complete indicates the completion of the analog input setup.
Setup Locked appears when user attempts to change a value or perform a function available only when the system is unlocked.
Setup Unlocked appears when user has unlocked the system for maintenance or troubleshooting.
(Question) ? asked by the control firmware; answer the question by pressing the yes/no, numeric digit, or am/pm key.
Wait for System Reset (6 Sec) appears while the EEPROM initializes.
Error Messages
When an error message appears, the entered information is not within the allowable parameters set by the control firmware or is not permitted as described below. In cases where the data was outside the parameters, press the Reset Menu key and enter the corrected information.
Access Denied appears when the user attempts to:
DEnter data prohibited by the master switch position,
DEnter data prohibited by the generator set state, or
DEnable the LDD (load disturbance detection).
Access Denied Idle Mode Active appears when the user attempts to modify the voltage regulator setup while the idle mode is active.
Alarm Active appears when the user attempts to modify an analog or a digital input that is active. See Menu
Cannot Change (because the) NFPA is Enabled appears when the user attempts to modify an RDO setting that is a NFPA 110 default requirement.
Cannot Change Preset appears when the user attempts to change the factory preset analog input, digital input, or input parameter.
EEPROM Write Error appears when a component failure occurs. Contact an authorized distributor/dealer.
Entry Unacceptable appears when the user attempts an invalid input to the voltage regulator setup.
Some alternators are intended to operate within a specific, limited range of conditions (voltage, frequency, and phase or connection). The following error messages can appear when attempts are made to enter system values that do not match acceptable conditions for the particular alternator.
DFixed Frequency when entry is beyond the range of limited entries for the respective alternator. Occurs when the alternator is not rated for the value entered. Updated parameter files may be available by contacting an authorized service dealer/distributor.
DFixed Phase when entry is beyond the range of limited entries for the respective alternator. Occurs when the alternator is not rated for the value entered. Updated parameter files may be available by contacting an authorized service dealer/distributor.
48 Section 2 Operation |
|
