SECTION 4: OPERATIONS
This tool presents serious injury hazards to untrained users. Read through this entire manual to become familiar with the controls and operations before using the tool!
EYE INJURY HAZARD!
Wear safety goggles with full eye protection from all sides when using this grinder.
LUNG/EAR
INJURY HAZARD!
Wear protective equipment when using this tool.
ACCIDENTAL
START HAZARD!
Disconnect power before service or wheel changes.
Wheel SHATTER
HAZARD!
Never exceed RPM rating for wheels.
Using the Angle Grinder
Read and understand all safety instructions in this manual before starting.
Always test on a scrap piece of material similar to the workpiece. Trial and error is often the best way to determine the ideal setup.
To use the angle grinder:
1.If the workpiece is not completely stable on its own, make sure it is securely held in a vise or a similar device that will ensure it does not move during operation.
2.Make sure the grinding wheel is proper- ly secured on the spindle by tightening the outer flange.
Never use this tool without the guard installed. DO NOT modify the guard in any way. Using this tool with a removed or modified guard greatly increases the risk of personal injury.
3.Attach the grinder to the correct power supply.
4.Hold the grinder securely in both hands, and turn it ON.
5.Ease the wheel against the workpiece with a light but steady pressure.
6.Turn the grinder OFF.
T10493, T10494 & T10495 (Mfg Since 10/11) |
