Installing/Changing
Grinding Wheels
These Angle Grinders use Type 27 grinding wheels. Refer to Specifications on Page 5 to match the grinder to the proper wheel. See Accessories on Page 11 for wheel options.
Always install a grinding wheel that is the correct size and RPM rating for your grinder. Failure to do so may cause injury from the grinding wheel failing and throwing pieces toward the operator at high speed.
Tools Needed | Qty |
Fixed Pin Spanner Wrench | 1 |
New Grinding Wheel | 1 |
To install or change the wheel: |
|
1.Press the spindle lock button and rotate the wheel until the button engages and the spindle ceases to turn.
2.While holding the spindle lock button, position the fixed pin spanner wrench in the outer flange and turn counterclock- wise to loosen the flange, as shown in
Figure 18.
Spindle Lock
Button
Hook
Wrench
Figure 18. Changing grinder wheel.
3.Remove the outer flange and old wheel.
4.Install the new wheel.
5.Replace the outer flange and tighten it while depressing the spindle lock button.
Note: The inner flange can unseat once the wheel is removed. Be sure the alignment keys of the inner flange seat properly to the grinder spindle and that the raised hub of the outer flange seats inside the bore of the grinding wheel, as shown in Figure 19.
Grinder Spindle |
Inner flange |
Wheel |
Outer flange |
Figure 19. Inner and outer flange
installation alignment.
T10493, T10494 & T10495 (Mfg Since 10/11) |
