4.See FIGURES 5&6. Loosen the LOCK Wheel (#18) to allow entire housing to turn. Rotate the housing to match the degree of angle you need on the Angle Gauge. Chains come in various sizes with varying degrees of sharpening angles. Check with your chain manufacturer’s manual to determine what degree you need to sharpen at. Once the degree is set, tighten the Lock Wheel(#18).
5.Lower the Top Housing(#4) so that the Grinding Wheel(#8) skims the chain tooth.
6.Hold it at that position while you Tighten the Lock Stop(#6)so that the Wheel will only go down to that point See FIGURE7.
7.Depending on the amount of material you wish to remove, tighten or loosen the Lower Knob(#26) and set the Lock Nut. Wee FIGURE5.The Lower
Konb (26) has a Lock Nut which will determine how much materail is removed. Once you set the Lock
Nut, fully tighten the Lower Knob(26).
the Lower Knob(26).
Page 6
