Grizzly T25227 owner manual Operations, Variable-SpeedDial, Multi-ToolUse

SECTION 4: OPERATIONS

	To perform a typical operation:
LUNG/Eye INJUry	1. diSCONNECT MULTI-TOOL FROM
		POWER!
HAzard!
Wear a respirator	2.	Install appropriate accessory tool for
and safety glasses		the operation (refer to Assembly sec-
when using this
		tion on Page 12).
tool.
ACCIDENTAL	3.	Put on safety glasses and a respirator.
Start HAZARD!
Disconnect power	4. Connect the multi-tool to power.
before servicing
or changing	5.	Firmly hold multi-tool, turn ON, and
accessories.
		adjust speed dial as necessary for job.

Variable-Speed Dial	6. While maintaining a balanced position,
	complete the operation with both hand
	on the multi-tool to ensure proper con-
The variable-speed dial adjusts the multi-	trol.
tool between 15,000 and 22,000 oscilla-	— if working	on a small	workpiece
tions per minute (OpM). The speed dial
	that could shift during operation and
can be set before starting the tool or while
	cause a loss of control, secure it with
in use.
	clamps or a vise.
Multi-Tool Use	— If working on a wall or other object
	that may have wiring, pipes, or other
	flammable	pressurized	material
The purpose of this overview is to provide	inside, inspect it carefully to ensure

the novice machine operator with a basic	you know what is on the other side
	of the cut.
understanding of how the machine is used
during operation, so the machine controls/
components discussed later in this manual
are easier to understand.

Due to the generic nature of this over- view, it is not intended to be an instruc- tional guide. To learn more about specific operations, read this entire manual and seek additional training from experienced machine operators, and do additional research outside of this manual by read- ing "how-to" books, trade magazines, or websites.

T25227 (Mfg. since 09/13) -9-