1- STEAM IRONING
Filling the water tank
A | B | C |
-Unplug your iron before filling it.
-Set the steam control to DRY (A).
-Take the iron in one hand and hold it with the point of the soleplate tilted downwards.
-To open the water tank stopper, turn it anticlockwise until the arrow on the stopper points to the “open padlock” symbol (B). It will lift automatically.
-Fill the tank up to the “MAX” line (C).
-Close the water tank stopper again by pressing it in and turning it clockwise until the arrow points to the “closed padlock” symbol (B).
Setting the temperature
D | E |
-Set the thermostat control (D) referring to the table below.
-The thermostat light comes on. It will go out when the soleplate is hot enough (E).
Setting the steam level
-In order to avoid water dripping from the iron onto the linen:
• Turn off the steam when ironing silk or synthetic fabrics.
• Set it at the minimum position for wool.
What temperature and which steam setting to use ?
FABRIC | POSITION OF | STEAM SETTING | ||
THERMOSTAT CURSOR |
| POSITION | ||
|
| |||
|
|
|
|
|
LINEN | MAX |
|
|
|
COTTON | ●●● |
|
|
|
WOOL | ●● |
|
|
|
SILK | ● |
|
|
|
SYNTHETIC | ● |
|
|
|
Polyester, Acetate, |
|
|
| |
Acrylic, Nylon |
|
|
|
|
|
|
|
| = STEAM ZONE |
|
|
|
| |
Recommendations:
Fabrics and ironing temperatures:
•Your iron heats up quickly : so begin by ironing fabrics that are ironed at low temperatures first, then go on to those requiring a higher temperature,
•if you turn down the thermostat, wait until the thermostat light comes back on before beginning to iron again,
•when ironing fabrics with mixed fibres, set the ironing temperature for the most delicate fibre.
For delicate fabrics we recommend testing the fabric first on an inconspicious place eg (inside the hem).
