Grundig VLE 7131 BF manual Displaying signal information

INFORMATION----------------------------------------------------------------------------------------------------------------------

Displaying signal information

(for digital channels only)

1Open the menu with »i«.

2Select the line »SOURCE SETUP« with »V« or »Λ« and press »●« to confirm.

3Select the line »Signal Information« with »V« or »Λ« and press »●« to confirm.

–Information on the channel, network, modulation, symbol rate, quality and signal strength is displayed.

Notes:

7The signal information changes in accord­­ ance with the current input source.

7The signal properties are displayed in the lower section of the menu.­ The further the bars for »Quality« and »Signal Strenght« extend to the right, the better the reception signal.

7The signal level not only depends on your receiver system, but also on the channel which is currently active. Remember this when aligning your antenna based upon the signal level display.

4Press »i« to close the menu.

Pre-programming the remote control for other GRUNDIG devices

7»DVB« has been pre-programmed for oper­­ ating a GRUNDIG digital receiver (remote control level 1). 

7»DVD« has been pre-programmed for oper­ ating a GRUNDIG DVD player.

7»AMP« has been pre-programmed for oper­ ating a GRUNDIG AV receiver.

7The functions available depend on the model of the device you are using. Just try it out.

Changing the pre-programming ­ of the remote control

1Press and hold »M« and simultaneously enter the three numbers of the corresponding­ code:

»1«, »2«, »3« for a GRUNDIG DVD player. »4«, »5«, »6« for a GRUNDIG DVD recorder. »1«, »4«, »7« for a GRUNDIG digital receiver (remote control level 1).

»2«, »5«, »8« for a GRUNDIG digital receiver (remote control level 2). »3«, »6«, »9« for a GRUNDIG digital receiver with a hard disk (PDR).

­56 ENGLISH