Hafler MAQ-104 owner manual S E S, Programmable TURN-ON Delay

INSTALLATION

The MAQ-104 is a precision piece of electronic equipment a n d w i t h p r o p e r i n s t a l l a t i o n w i l l p r o v i d e y e a r s o f t r o u b l e - f r e e operation. The following steps will help to reduce the amount of time and effort required to install the MAQ-104

>Consult a professional installer if necessary

>Mount the unit securely in a clean, dry location using the four internal mounting holes. The four mounting holes are located adjacent to the circuit board

>Make sure the installation does not interfere with the normal operation of the vehicle

POWER CONNECTOR

T h e f o u r p o w e r w i r e s o n t h e M A Q - 1 0 4 s h o u l d b e c o n n e c t e d as follows:

Yellow - connect to the + terminal of the battery.

Red - Connect to the remote turn-on lead from the source.

Black - Connect to the chassis of the vehicle The ground point in the car should be a piece of chassis m e t a l t h a t is welded to the main body of the car. Painted surfaces should be scraped or sanded before the ground lug is bolted down, (Cover the bare metal area with paint or grease to prevent rust.)

Blue - Connect to the remote turn-on leads of the amps

F U S E S

The battery wire (yellow) is fused on the circuit board with an AGC 1 amp fast blow fuse. The remote out wire (blue) is also fused on the circuit board with an AGC 1/2 amp fast blow fuse. In order to assure continued protection, replace only with the proper fuse values. See Figure 1 for proper fuse locations.

PROGRAMMABLE TURN-ON DELAY

The MAC-1 04 has the capability to delay the remote turn-on voltage to the amplifiers by a period of up to 4 seconds. This delay period is necessary in order to allow the signal

3