Haier 40503073 instruction manual Troubleshooting, Specications, Technical data, Packing list

Troubleshooting

Symptom		Things to Check	Solutions
	1	Whether the water supply
		has stopped or whether the	Check
No water		water pressure is too low
	2	Whether the water-usage
		point is blocked or whether	Check and clear
		the hot water valve is
		opened
	1	Whether hot water outlet is	Check and open
		opened
Only cold	2	Whether the water	Adjust water temperature
water but		temperature is adjusted
the heating	3	Heating time is too short
indicator lamp		and set temperature is not	Continue heating
is lit		achieved
	4	Whetehr heating pipe is	Con￿rm it is not due to the reasons under①
		damaged	② ③, then contact Maintenance Department
Only cold	1	Whether power is properly	Check power socket
		connected
water and
	2	Check whether there is
the heating			Connect power switch
		power supply
indicator lamp
	3	Whether thermostat is out	Con￿rm it is not due to the reasons under①②,
is not lit
		of control	then contact Maintenance Department
Heating	1	Water has not reached the	Continue heating
indicator light		set temperature
Is on all the	2	Whether thermostat is out	Con￿rm it is not due to the reason under①,
time		of control	then contact Maintenance Department
Water volume
is sometimes
large or small,	Whether water pressure is		Adjust water out￿owing volume or make sure
or water is	stable		water pressure is stable before using
sometimes
hot or cold
	1	Whether the present
Samll hot		temperature setting is too	Re-adjust the temperature setting
		low
water out￿ow
			As far as possible reduce the water valve's
volume	2	Whether water pressure is
			out￿ow volume during use; for details please
		too much
			refer to the tips in Important Notices

0040503073

V

Safety Notices (Please read before use)
Meanings of Icons	Compulsory Matters		Essential Matters
Prohibited
Forbidden	Warning		Caution
Immediately cut o￿ power supply and		Non-professionals are strictly prohibited
contact our Service Center once the		from carrying out repairs, maintenance,
water heater does not work properly or Forbidden		dismantling or revamping of the water
emits burnt smell.		heater.
230V/50Hz independent power source		Installation of water heater outdoors is
must be used at all times.		strictly prohibited.

Warning Forbidden

Haier Home Water Heater

Instruction manual

ES6V-Q1(H)ES6V-Q2(H)ES6V-Q1(H)ES6V-Q2(H)

Please read this Instruction Manual carefully before use. Please retain this manual for future reference.

Speci￿cations

Introduction of exterior and accessories

Back view Front viewSide viewCut view

c1

b1

a1

	To ensure safety, the water heater
	should be connected to independent
Earthing	sockets (do not use adapters), with
	reliable earthing. In addition the power	Forbidden
	socket must conform to national
	standards. Use of water heater without
	reliable earthing is strictly prohibited.
	Use pen multimeter to check whether
	the live line and zero line are reverse.
	Do not use damaged wire and power	Warning
	socket. Promptly clean the dust on the
Warning	power plug and socket.	Warning
	Check the power meter and the electric
	wire's diameter to ensure that they
Warning	comply with the rated current for the
	water heater. Where necessary engage
	quali￿ed electrician to check the	Caution
	electric circuit.

Do not touch the plug with wet hands, and make sure that the water heater, plug socket do not come into contact

Forbidden with water. If they are accidentally wet, they must be checked by professions appointed by our company before Forbidden using, in order to prevent electrocution.

Sotring of in￿ammable and explosive

items near the water heater is strictly Caution Forbidden prohibited.

Do not connect to power when installing or repairing the water heater.

Forbidden

1

Do not install the water heater in an environment which is susceptible to ice- formation. Ice will cause the container and water pipe to break, leading to scalding and water leakage.

Please take precautionary measures during cold weather, in order to prevent damage to water heater from freezing.

If the soft power cable is damaged, it must be replaced by professional sta￿ from the manufacturers or Maintenance Department in order to avoid danger.

Take care not to be scalded by heated water.

•Touching of hot water valve and pipes is strictly prohibited.

•Make sure to check the water temperature before use; use only when it feels suitable.

Do not use water from the water heater for drinking or similar purposes.

Please cut o￿ the power supply if the water heater was not used for an extended period of time. Drain the water heater of all water according to the instructions in the chapter on Cleaning and Maintenance.

	Model No.	Net weight	Volume	a1	b1		c1		d1		e1
		(kg)	(L)
	ES6V-Q1(H)	5	6	100mm	348mm		246mm	120mm		273mm
	ES6V-Q2(H)	5	6	100mm	364mm		266mm	100mm		285mm
A Hot water outlet					B Cold water intake						C Heating pipe
D Inner chamber					E	Anode rod

Note: The margin of error for the above parameters is ±10%.

Technical data

Rated voltage/	Rated	Rated	Waterproof	Rated	Water pressure
power	frequency	temperature	rating	pressure
230V~/2000W	50Hz	75°C	IPX4	0.80MPa	Not less than 0.05MPa

Packing list

Quantity Name of parts	Electric Water	Safety Valve/Water	Instruction	Expandable
Product Model No.	Heater (unit)	Drainage Pipe (set)	Manual (copy)	Hook (pcs)
ES6V-Q1(H)	1	1	1	2
ES6V-Q2(H)	1	1	1	2

Electrical Diagram

L: Brown wire

N:Blue line

MT: High temperature limiter

BT: Thermostat

HL: Heating indicator

EH: Heating element

E:Yellow/green wire

2