13Additional information
Chapter 13:
Additional information
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. Take a look at the other components and electrical appliances being used, because sometimes the problem may lie there. If the trouble isn’t sorted out even after going through the checks below, ask your nearest Pioneer authorized independent service company to carry out repair work.
•If the unit does not operate normally due to external effects such as static electricity disconnect the power plug from the outlet and insert again to return to normal operating conditions.
ProblemRemedy
The power does not turn on.
•Disconnect the power plug from the outlet, and insert again.
•Make sure there are no loose strands of speaker wire touching the rear panel. This could cause the receiver to shut off automatically.
•The unit may have been switched on using the wrong voltage setting. Make sure you switch the VOLTAGE SELECTOR on the rear panel to the right voltage for your country or region, then reset the unit (page 69) before switching on again.
The receiver suddenly switches | • After about a minute (you won’t be able to switch the unit on during this time), |
off and the power indicator | switch the receiver back on. If the message persists, call a Pioneer authorized |
blinks. | independent service company. |
|
|
No sound is output when a | • Make sure the component is connected correctly (refer to Connecting up on |
function is selected. | page 12). |
| • Press MUTE on the remote control to turn muting off. |
| • Press SPEAKERS to select the proper speaker set (see Switching the speaker |
| system on page 58). |
| • Press SIGNAL SELECT to select the proper input signal (see Choosing the input |
| signal on page 34). |
No image is output when a function is selected.
•Make sure the component is connected correctly (refer to Connecting up on page 12).
•Select the correct component (use the input select buttons).
•Check Assigning the component video inputs on page 62 to make sure you’re assigned the correct input.
•The video input selected on the TV monitor is incorrect. Refer to the instruction manual supplied with the TV.
No sound from subwoofer. | • Make sure the subwoofer is switched on. |
| • If the subwoofer has a volume knob, make sure it’s turned up. |
| • The Dolby Digital or DTS source you are listening to may not have an LFE channel. |
| • Switch the subwoofer setting in Speaker Setting on page 44 to YES or PLUS. |
| • Switch the LFE Attenuator Setup on page 64 to LFEATT 0 or LFEATT 10. |
No sound from surround or center speakers.
•Connect the speakers properly (refer to page 20).
•Refer to Speaker Setting on page 44 to check the speaker settings.
•Refer to Channel Level on page 45 to check the speaker levels.
66
En
