Pioneer VSX-917V-S/-K Power cord caution, Cleaning the unit, AM Tuner Section, Miscellaneous

Additional information 13

AM Tuner Section

Frequency Range

9 kHz step. . . . . . . . . . . . . .531 kHz to 1602 kHz 10 kHz step. . . . . . . . . . . . .530 kHz to 1700 kHz Sensitivity (IHF, Loop antenna). . . . . . . .350 µV/m Signal-to-Noise Ratio. . . . . . . . . . . . . . . . . . .50 dB Antenna . . . . . . . . . . . . . . . . . . . . . . Loop antenna

Miscellaneous

Power requirements

. . . . . . . . . . . . . . . . . .AC 110 V/AC 120 V to 127 V/ AC 220 V/AC 230 V to 240 V, 50 Hz/60 Hz Power consumption . . . . . . . . . . . . . . . . . . 395 W In standby. . . . . . . . . . . 0.5 W (AC 220 V/50 Hz)

Dimensions

. . . . . .420 (W) mm x 158 (H) mm x 352.5 (D) mm Weight (without package). . . . . . . . . . . . . . 8.7 kg

Furnished Parts

Microphone (for Auto MCACC setup) . . . . . . . . 1 Dry cell batteries (AA size IEC R6) . . . . . . . . . 2 Remote control . . . . . . . . . . . . . . . . . . . . . . . . . . 1 AM loop antenna . . . . . . . . . . . . . . . . . . . . . . . . . 1 FM wire antenna . . . . . . . . . . . . . . . . . . . . . . . . . 1 Power cords:

VSX-917V-K (black model) . . . . . . . . . . . . . . . .2 (Round 2-pin type and Australian type) VSX-917V-S (silver model). . . . . . . . . . . . . . . . .4 (Round 2-pin type, flat blade 2-pin type,

UK 3-pin type and Australian type)

Power plug adaptor (VSX-917V-K only) . . . . . . . . 1 J-shaped plug. . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 These operating instructions

Note

•Specifications and the design are subject to possible modifications without notice, due to improvements.

Manufactured under license from Dolby Laboratories. "Dolby", "Pro Logic", "Surround EX", and the double-D symbol are trademarks of Dolby Laboratories.

"DTS" and "DTS-ES Neo:6" are registered trademarks of DTS, Inc. "96/24" is a trademark of DTS, Inc.

Power cord caution

Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or an electric shock. Do not place the unit, a piece of furniture, etc., on the power cord, or pinch the cord. Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. Check the power cord once in a while. When you find it damaged, ask your nearest Pioneer authorized service center or your dealer for a replacement.

Cleaning the unit

•Use a polishing cloth or dry cloth to wipe off dust and dirt.

•When the surface is dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleansers.

•Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit, since these will corrode the surface.

English Deutsch Français Italiano Nederlands Español

71

En