04Controls and displays
PHASE – Press to switch on/off Phase
Control (page 11).
ACOUSTIC EQ – Press to select an Acoustic Calibration EQ setting (page 32).
DIALOG – Use to make dialog stand out when watching TV or a movie (page 34).
SOUND RETRIEVER – Press to restore CD quality sound to compressed audio sources (page 33).
9 SHIFT
Press to access the DVR controls (above the component control buttons) as well as some receiver controls.
10 INPUT SELECT
Use to select the input source (use SHIFT for
INPUT SELECT 
).
11 SOURCE
Press to turn on/off other components connected to the receiver (see page 50 for more on this).
12 Character display (LCD)
This display shows information when transmitting control signals.
The following commands are shown when you’re setting the remote to control other components (see Controlling the rest of your system on page 50):
SETUP – Indicates the setup mode, from which you choose the options below.
PRESET – See Selecting preset codes directly on page 51.
DIRECT F – See Direct function on page 52.
RESET – See Erasing all of the remote control presets on page 51.
READ ID – See Confirming preset codes on page 52.
13 RECEIVER
Switches the remote to control the receiver (used to select the green commands above the number buttons (DIMMER, etc)). Also use this button to set up surround sound (page 9, page 38).
28
14 VOL +/–
Use to set the listening volume.
15 MUTE
Mutes the sound or restores the sound if it has been muted (adjusting the volume also restores the sound).
16EFFECT/CH SEL
Press repeatedly to select a channel, then use +/– to adjust the level (see Tip on page 46). Also adjusts the level of the Advanced Surround effects, Dolby Pro Logic IIx Music, and Neo:6 Music parameters (page 30). You can then use the +/– buttons to make these adjustments.
Operating range of remote control
The remote control may not work properly if:
•There are obstacles between the remote control and the receiver’s remote sensor.
•Direct sunlight or fluorescent light is shining onto the remote sensor.
•The receiver is located near a device that is emitting infrared rays.
•The receiver is operated simultaneously with another infrared remote control unit.
30
30
7 m
En
