Haier AC142ACEEA Preparing Indoor Unit Installation, Floor Console Type, Drilling for Piping

Installation Procedures

PREPARING INDOOR UNIT INSTALLATION

1.REMOVE THE INTAKE GRILL

Open the intake grill and remove the three or four or six screws.(Fig. 1)

Fig. 1

Intake grill

A.FLOOR CONSOLE TYPE

1.DRILLING FOR PIPING

Select piping and drain directions.(Fig.2) The piping and drain can be made in three directions as shown below.

Remark:

The main unit can be wired before the indoor unit is installed. Select the most appropriate installation order.

When the directions are selected, drill a 7 cm dia. hole on the wall so that the hole is tilted downward toward the outdoor for smooth water flow. When the pipe is led out from the rear, make a hole in Fig.4, at the position shown.

(Fig.2)		(Fig.4)
		Wall
			6mm
	rear	7cm
	right	Indoor unit	outdoor unit
	down

The drain hose can be connected to either the	When installing set to wall, install the accessory wall
	bracket at the position shown in Fig.5,and mount the
left or right side.(Fig.3)
	set to it.

(Fig. 3) (Fig. 5)

65.5cm 53cm 4.5cm

Drain hose (Left side) Drain hose (Right side)

99cm

50cm 24.5cm

Wall bracket

Side of set

6.5cm
7cm hole		6.5cm
3.5cm hole
12.5cm	10cm

9