Installation and adjustment
Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine.
Midway spinning
Install the lint filter
Put the underside of the lint filter into overflow filter 
then push the upside into overflow filter.
After installation, please refer that the lint filter installed to the right station, otherwise the lint filter may be fallen off when washing, influencing your use.
overflow filter
lint filter
1.Put the laundries into the spin tub evenly and smoothly. 2.Spin
(1) Put the gland in properly.
Please put in the gland properly even if the laundries quantity is small. Push Gland
Push
Usage of the drain hose
The drainage shall be smooth with the drain hose.
1.The | height of the drain | hose shall be |
|
|
|
|
|
|
| |
less | than 10cm , or the | drainage will |
|
|
|
|
|
|
| |
not be smooth enough and cause |
|
|
| <10cm | ||||||
|
|
|
|
|
|
| ||||
incomplete drainage. |
|
|
|
|
|
|
|
|
| |
2.Do not tramp or press the drain hose.
3.If the drain hose is too long, cut it at mid point. To make smooth drainage, cut the front end of the hose slantingly.
4.If extra drain hose is needed , please make separate purchase. The inner diameter of the extra hose shall not less than 30mm, and the
length shall not exceed 1.5m. | > 30mm |
| |
| <1.5m |
If the extra hose is too long, cut it either at point A or B.
A B
4
Proper The laundries Proper No gland are slanting
(2) Close the inner and outer cover of the spin tub.
(3) Spin for | Outer cover of |
| the spin tub |
| Inner cover of |
| the spin tub |
3.Run the
1 Set the inlet selector handle on spin side and | Water inlet | |
fill water for about 1 min. | Inlet selector handle | |
In case water flows out from wash tub side |
|
|
due to too much inflow, please turn down |
| Wash Spin |
the water tap a bit. |
|
|
2 
Close the spin tub outer cover and spin
for about 1 - 2 min.
9
