Nortel Networks 4070 quick start Installing an Nsna device into a rack

26Installation

Check	Accessory	Use to
	copper network	Connect the network cables.
	interface card
	Console cable	Establish a console connection
		to the device.

—End—

Installing an NSNA device into a rack

Install an NSNA in a standard equipment rack.

Prerequisites for installing an NSNA into a rack

•Do not install the device in the network equipment racks

The following procedure describes how to rack-mount the device. Observe all safety and precautionary warnings in this procedure. Review Safety and installation precautions before proceeding with the installation process.

To install the Nortel Secure Network Access Switch, perform the following tasks. Throughout the following procedure, bold numbers in brackets are presented. These correspond with the numbers in the step illustration to provide a visual reference for the installation procedure steps.

Procedure steps

Step Action

1Hold the left and right slide rails and separate them from the other device hardware. Take one slide rail and push outward on the slide rail latch (1) and pull the latch back to open the slide rail (2). The latch catches to stay open. Repeat the procedure for the other end of the slide rail and then again for the other slide rail provided.

Nortel Secure Network Access

Installation — Quick Start Switch 4070

NN47230-303 01.01 Standard

2.0 28 July 2008

Copyright © 2008, Nortel Networks