Cabling the device, Connecting serial cables | Nortel Networks 4070

30Installation

—End—

ATTENTION

To remove the device, reverse these instructions.

Cabling the device

This section describes about cabling the device for network and console connections.

Cabling the device navigation

•"Connecting network cables" (page 30)

•"Connecting serial cables" (page 30)

Connecting network cables

The Nortel Secure Network Access Switch 4070 contains copper network interface card running at Intel Dual LAN 10/100/1000.

Connecting serial cables

This section describes how to connect a DB9 serial cable to establish a console connection to the device.

Nortel Secure Network Access

Installation — Quick Start Switch 4070

NN47230-303 01.01 Standard

2.0 28 July 2008

Copyright © 2008, Nortel Networks

Image 30

Nortel Networks 4070 quick start Cabling the device navigation, Connecting network cables, Connecting serial cables

Contents

Installation Quick Start Switch Legal Notice Contents Installation Regulatory Information and Safety Precautions International Regulatory Statements of Conformity EN 55022 statement Ices statement Canada onlyCE marking statement Europe only EN 55024 statement MIC notice Republic of Korea only National Safety Statements of Compliance EN 60950 statementVcci statement Japan/Nippon only NOM statement Mexico only Denan statement Japan/Nippon only Información NOM unicamente para México National Environmental Statements of Compliance Weee Directive Compliance Statement Regulatory Information and Safety Precautions Trademarks Trademarks Regulatory Information and Safety Precautions Software license Nortel Networks software license agreement General Nortel Networks software license agreement Software license Features New in this releaseOther changes New in this release Introduction PrerequisitesNavigation Introduction Safety precautions navigation Installation preparationSafety precautions Personal safety before installing the device Cable and connector safety Installation checklist Procedure steps Installation preparation Installation Unpacking the device Installing an Nsna device into a rack Prerequisites for installing an Nsna into a rack Installing an Nsna device into a rack Installation Installing an Nsna device into a rack Cabling the device Connecting network cablesConnecting serial cables Cabling the device navigation Serial connection parameters Parameter Value Installation Conﬁguration Creating a new clusterPrerequisites Specify the network connectivity port Enter a default gateway address Joining an Snas to an existing cluster Procedure steps Enabling the browser-based interface To enable the BBI, perform the following procedure Applying the Nortel Snas license Endpoints Through BBI Enter the command /cfg/sys/host hostnumber/license Page Installation Quick Start Switch