Nortel Networks 4070 quick start Enabling the browser-based interface

38Configuration

6Enter the Management IP address (MIP) of the existing cluster.

Provide the Management IP address of the cluster to which you want to join the new SNAS. To check the Management IP of an existing cluster, connect to the cluster and use the /cfg/sys/cur command.

7Provide the correct admin user password.

—End—

The SNAS that is joined to the cluster automatically picks up all configuration data from an installed SNAS in the cluster.

Wait until the Setup utility gets finished.

The login prompt appears.

Log in as admin to continue to configure the SNAS cluster using the CLI or the BBI.

Enabling the browser-based interface

The SNAS browser-based interface (BBI) is not immediately available for use when the device is first commissioned. The BBI can be enabled to work over HTTP, HTTPS, or both protocols. It is recommended the default ports of 80 (HTTP) and 4443 (HTTPS) be changed when it comes to device management. HTTP and HTTPS client traffic is connected through these default ports and if used in device management cannot be available to service requests.

Nortel Secure Network Access

Installation — Quick Start Switch 4070

NN47230-303 01.01 Standard

2.0 28 July 2008

Copyright © 2008, Nortel Networks