Joining an SNAS to an existing cluster 37
Procedure steps
Step Action
1Choose join from the Setup menu to add an SNAS to an existing cluster.
2Specify the port to be used for network connectivity.
Enter port number for the management interface
This port is automatically assigned to Interface 1. This interface can be used for both management traffic (coming from the private intranet) and client traffic (coming from the public Internet).
If port 1 is the management interface port for existing SNAS(s), Nortel recommends that you configure port 1 for the new SNAS as well.
3Enter the new SNAS host IP address.
This IP address should be within the same network address range as the cluster’s Management IP address.
4Enter the network mask.
Specify the desired network mask or press Enter to accept the suggested value. If a connected router or switch attaches VLAN tag IDs to incoming packets, specify the VLAN tag ID to use.
5Press Enter to create a
Nortel Secure Network Access
Installation — Quick Start Switch 4070
2.0 28 July 2008
Copyright © 2008, Nortel Networks
