Desa CF26NRA Instructions on page, Continued, To Turn Off Gas To Appliance, Propane/LP, Pilot

OPERATING FIREPLACE

Continued

10.Wait one minute and switch selector switch to the ON position to light burner.

11.Set flame adjustment knob to any level between HI and LO.

CAUTION: Do not try to ad- just heating levels by using the equipment shutoff valve.

WARNING: Make sure the selector switch is in the OFF position when you are away from home for long periods of time. Heater will come on automati- cally with selector switch in the ON position.

Pilot Burner	Ignitor
	Electrode

	Pilot Burner
Propane/LP	Natural Gas

Figure 35 - Pilot

TO TURN OFF GAS

TO APPLIANCE

Shutting Off Heater

1.Turn control knob clockwise to the OFF position.

2a.	Set selector switch in the OFF position
2b.	If Using Optional Hand-Held Remote: Set
	selector switch in the OFF position to keep
	from draining battery.
Shutting Off Burner Only (pilot stays lit)
You may shut off the burner and keep the pilot
lit by doing one of the following:

1.Turn control knob clockwise to the PILOT position.

2.Use remote control manual OFF button.

3.Set selector switch in the OFF position.

MANUAL LIGHTING

PROCEDURE

1.Follow steps 1 through 6 under Lighting Instructions, page 20.

2.Depress control knob and light pilot with match.

3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow steps 9 through 11 under Lighting Instructions, page 20.

OPTIONAL HAND-HELD

REMOTE OPERATION

Note: All remote control accessories must be purchased separately (see Accessories, pages 35). Follow instructions included with the re- mote control.

NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on page 20.
After lighting, let pilot flame burn for about one
minute. Turn control knob to ON position. Adjust
flame adjustment knob anywhere between HI and
LO. Slide the selector switch to the REMOTE
position (see Figure 36). Note: The burner may
light if hand-held remote was on when selector
switch was last turned off. You can now turn the
burner on and off with the hand-held remote
control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
Flame	Control Knob
	in On Position
Adjustment Knob
	IH		F	PI
ON				LO
		O	F	T
OFF				O
REMOTE				N
	LO
Selector Switch in Remote Position
(Optional Remote Control)
Figure 36 - Setting the Selector Switch,
Control Knob, and Flame Adjustment
Knob for Remote Operation

113897-01A www.desatech.com 21