INSTALLATION
Continued
Note: All vertical | Mantel Shelf | |||
|
|
|
| |
measurements | 10" |
|
|
|
are from top |
|
|
| |
8" |
|
|
| |
of fireplace |
|
|
| |
|
|
|
| |
opening to | 6" |
|
|
|
|
|
| ||
bottom of | 2 1/2" |
|
|
|
|
|
| ||
mantel shelf. |
|
|
|
|
Minimum Non- |
|
|
|
|
Combustible |
|
|
|
|
Material | 13" | 16" | 19" | 21" |
| ||||
|
|
|
|
|
Figure 8 - Minimum Mantel Clearances
for Built-In Installation
REMOVING BRICK LINER
RETAINER
1.Using Phillips screw driver, remove 2 screws attaching brick liner retainers to vertical sides.
2.Remove brick liner retainers and discard. Replace 2 screws into vertical sides.
ASSEMBLING TRIM
(Trim shipped with mantel)
1. Remove packaging from three pieces of trim.
2. Locate two adjusting plates with set screws, and two shims in the hardware packet.
3. Align shim under adjusting plate as shown in Figure 9.
4. Slide one end of adjusting plate/shim in slot on mitered edge of top trim (see Figure 9).
5. Slide other end of adjusting plate/shim in slot on mitered edge of side trim (see Figure 9).
6. While firmly holding edges of trim together, tighten both set screws on the adjusting plate with slotted screwdriver.
7. Repeat steps 1 through 6 for other corner.
8. Set trim assembly aside for later installation.
Slot
Set Screws |
| Top |
|
| |
|
| Trim |
| Shim | Mitered |
| Edge | |
|
|
Side
Adjusting Trim
Plate
Slot
Figure 9 - Assembling Trim
OPTIONAL MANTEL INSTALLATION
Note: Refer to instructions provided with the man- tel for assembly instructions. Refer to instructions below for system installation. If using blower ac- cessory (see Accessories, page 35), see installation instructions on pages 12 through 15.
1.Choose location for fireplace and install gas supply line.
2.Remove screen from fireplace by removing screws in each end of screen rod (see Figure 10). Hold screen rod cover while removing five hex head screws underneath hood (see Figure 11). Carefully lift and pull out hood (see Figure 12, page 12).
Figure 10 - Removing Screen
Hood
Screen Rod
Cover
Screw
Figure 11 - Removing Hood Screws
www.desatech.com | 11 |