Desa CF26NRA, CF26PRA installation manual Continued, Installing Blower Bracket Assembly

INSTALLATION

Continued

8.Insert the 4 wire harness into one of the round holes in the rear of the blower control shield and through the rectangular hole in the front of shield (see Figure 15).

9.Reconnect red wire to the AUTO switch posi- tion. Reconnect blue wire to the ON switch position. Reconnect green and white wires to the power cord.

10.Install the switch plate on the blower control shield with 2 - #10 screws provided (see Fig-

ure 16). Route power cord out of the cabinet by inserting it through the bushing on the outer casing (see Figure 15). Plug fan kit into 120-Volt grounded power supply and test operation. Note: When switch is in the AUTO position, the fan will start after the heater has run for a few moments. The fan will continue to run for several moments after the heater has been turned off. When switch is in the ON position, the fan will run until turned to OFF. Reinstall hood assembly and close lower louver door.

Wiring Routing Hole

Blower Bracket

Assembly

Screw

Heat Deflector

Switch
	Wire Harness
	Power
	Cord
	Red
Blue
Switch Plate	Wire
	Harness
Blower
Control
Shield

Shield Cover

Figure 15 - Installing Blower Bracket Assembly

Blower Control

Shield

Switch Plate Screw Figure 16 - Installing Switch Plate to Blower Control Shield

113897-01A www.desatech.com 13