INSTALLATION
Continued
4.Install remote receiver unit onto gas log heater base using clips (2) and insulating washers provided.
5.Push clips firmly into place (see Figure 29).
6.Connect wires as shown in Figure 30.
FrontFront
Mounting
Clips
Back
Remote
Receiver
Insulating Washers
Figure 29 - Installing Remote Receiver
Valve
White Wire
From Receiver
Red Wire From
Receiver
Figure 30 - Connecting Wires
Receiver
| Terminal |
Battery | Wires |
| Battery Clip |
Figure 31 - Installing Receiver on the | |
| Back of the Base |
Installing | |
|
1.Remove battery cover on back of remote control unit.
2.Attach terminal wires to the battery. Place battery into the battery housing.
3.Replace battery cover onto remote control unit.
| Battery | Remote | |
Terminal | Cover | ||
Control Unit | |||
| |||
Wires |
|
| |
|
| ||
Battery |
|
| |
|
| Battery | |
|
| Housing | |
Figure 32 - Installing Battery in | |||
Remote Control Unit (CGHRCB Series) |
INSTALLING WIRELESS REMOTE CONTROL ACCESSORY
Two
Installing 9-Volt Battery in Receiver
1.Locate back of receiver under front burner of heater.
2.Locate the battery clip mounted on the back of the receiver.
3.Slide a
4.Attach the terminal wires to the battery.
Terminal | ||
Wires | ||
Battery | ||
|
| Remote |
| Control |
Battery | Unit |
| |
Cover |
|
Figure 33 - Installing Battery in | |
Remote Control Unit (CGHRCTB Series) |
www.desatech.com | 19 |