Cabling the device 31
Procedure steps
Step Action
1Prepare either an ASCII terminal or a computer running terminal emulation software to serve as the command device.
2Configure the terminal or computer with the following parameters:
Serial connection parameters
Parameter | Value |
|
|
Baud Rate | 9600 |
|
|
Data Bits | 8 |
|
|
Parity | None |
|
|
Stop Bits | 1 |
|
|
Flow Control | None |
|
|
3Connect one end of the serial cable to the terminal or computer.
4Connect the other end of the serial cable to the serial connector located at the rear of the device.
5Proceed with establishing the console connection.
—End—
Nortel Secure Network Access
Installation — Quick Start Switch 4070
2.0 28 July 2008
Copyright © 2008, Nortel Networks
