Haier DW12-PFE2, DW12-PFE2 ME How to fill rinse aid, How to fill the detergent dispenser

This product makes dishes sparkle and helps them to dry without

spotting. The dispenser is located on the inside panel of the door .

Regardless of the type of detergent dispenser installed on your

appliance, you must proceed as indicated below when load ing t he ri ns e

aid.

To open the dispenser, turn the "2" cap in an anti-clockwise direction

and then pour in the rinse aid, making sure not to overfill. The amount

of rinse aid used for each cycle can be regulated by turning the " 3"

dose adjustor, located beneath the "2" cap, with a screwdriver. There

are 6 different settings; the normal dosage setting is 3.

How to fill rinse aid

When the low rinse aid indicator “H” lights, you must load rinse aid .

How to fill the detergent dispenser

Important

Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spot-

ting occurs, the dosage adjustor should be turned to a higher setting. If the dishes have white

streaks, turn the dosage adjustor to a lower setti n g.

Detergent specifically intended for use with dis hwashers must be used.

The dispenser must be refilled before the start of each wash cycle

following the instructions provided in the "Programme overview". The

detergent dispenser is located on the inside panel of the door.

To open the " 4 " cover on the dispenser, press the "5" button.

The detergent for the wash cycle should be poured into the " 6 "

compartment.

The detergent for the pre-wash cycle should be poured into the

“ 7 ” compartment.

After the detergent has been placed in the dispenser, close the

cover and press down until it clicks in place.

To facilitate closing the cover, remove any excess detergen t on the ed ges of the dispenser.