Cancelling or modifying a cycle
A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled ( see the para- graph entitled, “ Loading the detergent ”).
To modify a cycle that is already underway, press the button“ A ” , all of the settings will be cancelled. To set a new cycle, follow the instructions contained in the para- graph entitled “Switching the dishwasher ON”.
A
It is recommended that adjustments be made in accordance with the following table:
| Water Hardness |
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
| Selector | Salt | Autonomy |
Level |
| Clarke | ºdH |
| c o n s u m p t i o n | ||
| mmol/l | (cycles/2kg) | |||||
|
| degrees |
|
| position | (Grams/cycle) |
|
|
|
|
|
|
|
|
|
1 |
| 014 | MNT | MNIT | L | M | L |
|
|
|
|
|
|
|
|
2 |
| NQPS | NUQQ | NIUQIQ | =?J? | OM | SM |
|
|
|
|
|
|
|
|
3 |
| PSTN | QRUV | QIRUIV | jba | QM | QM |
|
|
|
|
|
|
|
|
4 |
| [TN | [UV | [UIV | ?H? | SM | OR |
|
|
|
|
|
|
|
|
Programme cycle progress indicator
The dishwasher is equipped with a LCD screen “ 11 ” that lights when the appliance is switched on by his light itself.
From left to right, the phases in the cycle are: prewash, wash, rinse and dry ( indicator 3 ).
11 |
Rinse aid
This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the door and should be filled after low rinse aid indicator “ 2 ” lights.
2 |
During every phase of the wash cycle, the correspond- ing indicator blinks. At the end of the programme, there is a beep and the screen light will go out.
Loading the rinse aid
Regardless of the type of detergent dispenser installed on |
|
your appliance, you must proceed as indicated below when |
|
loading the rinse aid. |
|
To open the dispenser, turn the " 3 " cap in an | 3 |
wise direction and then pour in the rinse aid, making sure |
|
22
1/2 Load Button
This button E (see"
To select the upper 1/2 load:
Select the programme ( see the paragraph entitled“ Switching the dishwasher ON”)
Press the 1/2 load button “ E ” , upper 1/2 load indicator “ 14 ” lights on.
Press the start button“ D ” .
Close the door.
4 |
not to overfill. The amount of rinse aid used for each cycle |
can be regulated by turning the "4" dose adjustor, located |
beneath the "3" cap, with a screwdriver. There are 6 differ- |
ent settings; the normal dosage setting is 3. |
Important
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs, the dosage adjus- tor should be turned to a higher setting.
If the dishes have white streaks, turn the dosage adjustor to a lower setting.
11