How to fill the salt container and the rinse aid dispenser
Salt
The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils.
The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water.
Loading the salt into the container
Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and should be filled as follows:
When the low salt indicator “1” lights, you must fill the salt. |
|
|
|
| |
|
|
|
| ||
Remove the lower rack and then unscrew and remove |
|
|
|
| |
the cap from the salt container; |
|
|
|
| |
If you are filling the container for the first time, fill it with |
|
|
|
| |
|
|
|
| ||
|
|
|
| ||
water; |
|
|
| ||
1 |
| ||||
Place the end of the funnel (supplied) into the hole and |
|
|
|
| |
|
|
|
| ||
introduce about 2 kg of salt. It is normal for a small amount |
|
|
|
| |
of water to come out of the salt container. |
|
|
|
|
|
Carefully screw the cap back on. |
|
|
|
|
The salt container must be filled when the "low salt indicator" (located on the control panel) lights.
To prevent the formation of rust, load the salt just before
beginning a wash cycle.
Adjusting salt consumption
The dishwasher is designed to allow for adjusting the amount of salt consumed based on the hardness of the water used. This is intended to optimize and customize the level of salt consumption so that it remains at a minimum.
To adjust salt consumption, proceed as follows:
Unscrew the cap from the salt container;
There is a ring on the container with an arrow on it (see figure to the side),
If necessary, rotate the ring in an anticlockwise direction from the " - " setting towards the " + " sign, based on the hardness of the water being used.
10
BD
C14 E
To select the bottom 1/2 load:
Select the programme ( see the paragraph entitled“ Switching the dishwaher ON”)
Press the 1/2 load button “ E ” , upper 1/2 load indicator “ 14 ” lights on. Press the 1/2 load button“ E
”twice, botton 1/2 load indicator “ 15 ” lights on. Press the start button “ D ” .
Close the door.
- Please keep in mind that the amount of detergent should also be adapted to the 1/2 load.
- To cancle the 1/2 load, you can press the 1/2 load button “ E ”,until the 1/2 load indicators “15” goes out.
BD
|
|
|
|
|
C |
| E | ||
|
15
23