Haier DW9-TFE1 operation manual How to fill rinse aid, Rinse aid, Loading the rinse aid

en

It is recommended that adjustments be made in accordance with the following table:

Hardness of the water			Selector	Salt	Autonomy
			knob	c o n s u m p t i o n
					(cycles/2kg)
ºdH	ºfH	ºmmol/l
			position	(Grams/cycle)
0J10	MJNT	MJNIT	L	M	L
NMJOR	NUJQQ	NIUJQIQ	=?J?	OM	SM
ORJRM	QRJUV	QIRJUIV	jba	QM	QM
[RM	[UV	[UIV	?H?	SM	OR

The default setting of the water softening system is -.

-If using multi-functional tablets fill the salt dispenser and set the adjuster to -; if the hardness of the water is greater than 60ºfH, set it to +.

How to fill rinse aid

Rinse aid

This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the door. When the low rinse aid indicator “ 1 ” is bright ,it means the rinse aid is low,you must load rinse aid .

1

Low

Full

Loading the rinse aid

Regardless of the type of detergent dispenser installed on your
appliance, you must proceed as indicated below when loading the
rinse aid.
To open the dispenser, turn the "2" cap in an anti-clockwise direction	2	3
and then pour in the rinse aid, making sure not to overfill. The amount
of rinse aid used for each cycle can be regulated by turning the "3"
dose adjustor, located beneath the "2" cap, with a screwdriver. There
are 6 different settings; the normal dosage setting is 3.

Important

Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spot- ting occurs, the dosage adjustor should be turned to a higher setting. If the dishes have white streaks, turn the dosage adjustor to a lower setting.

8