Drain hose connection, Electrical Connection | Haier HDW12-TFE3WH

Drain hose connection

EN

Drain hose connection

Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink, making sure to avoid bending or crimping it. If necessary, fit a syphon trap (U-bend) with a connecting piece for the electrical drain hose (fig.B). The free end of the hose must be at a height between 40 and 100 cm and must not be immersed in water.

fig.B

Attention:

The connecting piece for syphon trap (U-bend) must be securely fastened to the wall to prevent the drain hose from moving and allowing water to spill outside the drain.

Electrical Connection

After making sure that the voltage and frequency values for the current in the home correspond to those on the rating plate (located on the stainless steel inner door of the appliance) and that the electrical system is correct for the maximum voltage on the rating plate, insert the plug into an electrical socket which is earthed properly (the earthing of the appliance is a safety requirement mandated by law).

If the electrical socket to which the appliance must be connected is not appropriate for the plug, replace the whole cable, rather than using adaptors or the like as they could cause overheating and burns.

Caution:

The dishwasher plug must be accessible even when the appliance is installed as a built-in unit so that maintenance can be done safely.

5

Image 6

Haier HDW12-TFE3WH, HDW12-TFE3SS manual Drain hose connection, Electrical Connection

Contents

Dishwasher HDW12-TFE3SS HDW12-TFE3WH Instructions for Use 0120504778D Index During normal use During installationAt time of delivery Safety information If your family includes children If a fault occursWhen disposing of old appliances Dangerous voltage Levelling the appliance InstallationPositioning the appliance Cold water connection Drain hose connection Electrical Connection Getting to know your dishwasher Close-up view control panelDishwasher interior Loading the rinse aid How to fill rinse aidRinse aid When the low rinse aid indicator Hon the control panel and the me How to fill the detergent dispenser DetergentLoading the detergent Our recommendation Not suitable for the dishwasherWhat you should not put into the dishwasher Damage to glassware and other dishes Pull out the rack to load the dishwasher How to use the lower rackArranging crockery, glasses, etc. in the dishwasher EN Pots, serving bowls, etc. must always be placed face down. see fig.C How to use the upper rack ShelfKnife rack HEAVY NORMAL Programme overviewTypes of load QUICK RINSE Programme selection Switching the dishwasher ONWashing dishes Earn savings Interrupting the programme Switching the dishwasher OFFEnd of programme Delayed start programming HALF LOAD Button Cancelling or modifying a cycleReset drain function To select HALF LOAD When You Go on Holiday How to keep your dishwasher in shapeNo solvents or Abrasive Cleaning Products After Every Wash Rinse-aid Care and maintenanceOverall condition of appliance Filters Problems when the appliance is switched on Trouble ShootingResolving minor problems yourself Spray arms Error display on the time-remaining indicator Have you checked whether Lower spray arm rotates with difficulty Lid in detergent compartment cannot be closedRemnants of detergent stuck inside dispenser Water remains inside appliance after programme has ended during washingwith the dishes,cutlery, etc Unusual amount of foam is creased Dishes,cultlery,etc.have not been dried Plastic items are discolouredWhite stains are left on crockery, glasses have a milky appearance Glasses have a dull appearance Technical data Important informationNotes on waste disposal General information