Installation procedures
Display of whole unit
Try to bring the packed unit to the installation place.
When it is inevitable to unpack the unit, be careful not to damage the unit. Wrap it with nylon etc.
After unpacking, be sure to put it with the front side of the unit facing up.
Note: When delivering, don't hold plastic parts like inlet and outlet grill etc.
Delivery
Facing up
Installation of outdoor unit
Selection of installation place
Place strong enough to support the unit and will |
| over 30cm |
|
| |
not cause vibration and noise. |
|
|
Place where discharged wind and noise doesn't |
|
|
cause a nuisance to the neighbors. |
|
|
Place where is less affected by rain or direct |
|
|
sunlight and is sufficiently ventilated, or to install | over 10cm |
|
a shield. | over 10cm | over15cm |
| ||
Place with enough space for smooth air flow. | over 60cm |
|
Fixing of the unit
Fix outdoor unit using M10 bolt to concrete floor horizontally.
If installed on the wall or on top of a roof, bracket should be fixed securely to resist earthquake or storms.
Use rubber pad during installation against unit vibration.
410
447 | 340 | 380 |
|
|
|
1008 | 580 | 180 |
| ||
| 948 |
|
| ||
Installation dimension of outdoor unit (mm) |
| |
13
