Haier HSU-09RS03/R2(SDB), HSU-12RK03/R2(SDB) Clock set, Loading of the battery, Hint

Operation

Inner side of the controller
				operating power is 100W;
				when the panel display “02”,
SMART	SET TEMP. ROOM TEMP.			the operating power is
COOL				200W, and so forth)
HEAT				21.LIGHT button
FAN
DRY	AUTO	AUTO		Control the lightening and
CTD			AUTO	extinguishing of the indoor
POWER	FAN
	SPEED			LED display board.
SOFT
ECO				the manual of how to display
iFP		TIMER ON	OFF
	AM			set temp：
	PM			Press LIGHT button continuously
26
				27 for ten times, the display temp on
SMART				display panel can be changed

2Load the batteries as illustrated. 2 R-03

batteries,resetting key(cylinder); Be sure



that the loading is in line with the" + "/"-";

3

Load the battery,then put on the cover again.

Clock set

25		from ambient temp to set temp.
	28
		Set temp function only valuable
24
	29	for RS.
23	30	22.POWER / SOFT button
	31	23.10
22		special heating set function:
21	32	10 degree heating maintaining
		(valuable for RS)
20
19	33	24.HEALTH AIRFLOW
18	34	button
		25.HEALTH button

AM

PM

1Press CLOCK button,

"AM" or "PM" flashes.

2Press “+” or “-” to set correct time.

18.CODE button

Used to select CODE A or B with a press, A or B will be displayed on LCD.Please

select A without special explanation.

19.RESET button

When the remote controller appears abnormal,use a sharp pointed article to press this button to reset the controller normal.

26.SWING UP/DOWN button

27.SWING LEFT/RIGHT button

28.FRESH button 29.SLEEP button 30.TIMER ON / OFF button 31.HOUR button

32.CANCEL/CONFIRM button

Used to confirm timer and clock settings.

SMART

Each press will increase or decrease 1min.If the button is kept pressed,time will change quickly.

3Confirm time.

After time setting is confirmed, press CONFIRM,"AM "and "PM" stop flashing,while

20.INQUIRE button	33.CLOCK button
Inquire the external	34.LOCK button
environmental temperature
	If pressed, the other buttons
and the operating power of
	will be disabled. Press it once

Note:

clock starts working.

the machine. (e.g. when the	again,lock will be cancelled.
panel display “01”, the

This function unavailable on this models.

Loading of the battery

1

Remove the battery cover;

The distance between the signal transmission head and the receiver hole should be within 7m without any obstacle as well. When electronic-started type fluorescent lamp or change-over wireless telephone is installed in the type fluorescent lamp or

room, the receiver is apt to be disturbed in receivingthe signals,

so the distance to the indoor unit should be shorter.

Full display or unclear display during operation indicates the batteries have been used up.Please change batteries.

If the remote controller can’t run normally during operation, please remove the batteries and reload several minutes later.

Hint:

Remove the batteries in case unit won’t be in usage for a long period.If there are any display after taking-out,just need to press reset key.

3