Installation instruction
Selection of the installation position
1.Select position where the structure is firm.
2.Select position where the air inlet and outlet are smooth without obstacles.
3.Select position where the cooled air can be blown to every corner.
4.Select position where there's no direct sunlight. If the sunlight is inevitable, sun shading device is required.
5.Select position where the outdoor airflow will not influence the neighbors.
6.Select position where the drainage is smooth.
7.Select position where there's no dangerous gas or oil smoke nearby.
8.An extension cord is not recommended.
Installation diagram
It should be installed like this: the back side (outdoor side) is lower so that the drained water can flow out smoothly.
Width of the wall should be less than 295mm
5 ~ 10mm
>400mm
>400mm
>400mm
>700mm
Requirements on electricity
Be sure to use specific power circuit.
The enclosed accessories of the conditioner are:
Name | Manual | Water outlet pipe | Seal ring |
Figure
Quantity | 1 | 1 | 1 |
10