fig.1 fig.2
3.
1. 2.
4.
fig.3
07
BEFORE USE
ADjUStiNg thE BOttOM cOvER
Before removing the transportatio n bolts, please fix the
bottom cover to the bottom of the washer dr yer. Lay down
the machine (fig. 1.), screw off the feet and adjust the
bottom cover with the four holes correspon ding the screw
holes of the feet. Then screw the feet back on through t he
cover and fix it thus securely to the bottom of t he machine
(fig. 2.).
It keeps out the dampness and reduces the noise.
DiSMANtLE thE tRANSpORtAtiON BOLtS
The transportation bolts are des igned for clamping anti-
vibration components inside of the washer dr yer during the
transportation process.
1. Remove the back cover.
2. Remove the three bolts on the rear si de and take out
the synthetic stabilisers from wit hin the machine.
3. Replace the back cover.
4. Fill the holes left by the bolt s with blanking plugs.
Note:
1.When you replace the back cover,the convexity must face to outside,
and you have to insert the back cover from the two gaps as shown
in fig.3.
2.Keep the transportation bolts and synthetic stabilisers
in a safe place for later use.
ADjUStiNg thE WAShER DRYER
There are adjustable feet under the botto m of the washer dryer. Before use, they
should be adjusted so that the machine is level. Th is will minimise vibrations and
thus noise during use. It will also reduce wear and tear. We recommend usi ng a
spirit level to level the appliance.
InStALLAtIon