18 MAINTENANCE
DISPLAY CoDES
CoDES CAUSES SoLUTIoNS
Err1 ¬ Washer door is not properly shut.
_
Shut the door properly
Err2 ¬ Drainage error. Water is not emptied
within 4 minutes.
_
Cl ea n t he fi lt er an d c he ck th e d ra in ho se f or bl oc ka ge .
Remove filter in case any water remains in the unit.
Err3 ¬ Temperature sensor error.
_
Please contact the Service Center.
Err4 ¬ Heater error or laundry overload. The set
temperature is not reached within specified
ti me . ( Ap pe ar s a t t he en d o f a c y cl e ) .
_
Reduce load and start washing again.
_
Please contact the Service Center.
Err5 ¬ Water level not met within 8 minutes.
_
Check the tap and the water pressure.
Err6 ¬ Dehumidification/heating error.
_
Please contact the Service Center.
Err7 ¬ Motor overheat error.
_
Please contact the Service Center.
Err8 ¬ Water overflow.
_
Please contact the Service Center.
Err9 ¬ E rr or of th e d r ye r t em pe ra tu re se ns or .
_
Please contact the Service Center.
Er10 ¬ Error of the water level sensor.
_
Please contact the Service Center.
Er12 ¬ Error of the dryer water level sensor.
_
Ch ec k w he th er cl ot he s a re dr y o r no t a nd wh et he r t he re is
water still in the drum. If so allow excess humidity to
es ca pe fr om th e a pp li an ce an d t r y t he dr yi ng cy cl e a ga in .
Er13 ¬ Dryer heater error.
_
Please contact the Service Center.
unb ¬ Laundry is unevenly distributed.
_
Redistribute laundry to balance the drum.
EUAr ¬ Communication error.
_
Please contact the Service Center.
1:16 ¬ Status information: remaining program time is 1 hour and 16 minutes.
0:01 ¬ Status information: remaining program time is 1 minute.
60°C ¬ Status information: Wash temperature is 60°C.
--°C ¬ No heat (cold wash).
0 ¬ No spin.
800 ¬ Status information: Spin speed 800 rpm.
L--1 ¬ Manually selected code when laundry weight is less than 1kg.
L--A ¬ Manually selected code when drum is nearly full.
End ¬ Program is finished.
DISPLAY CoDES AND SPECIAL fUNCTIoNS
¬ C on tr ol pa ne l l oc k f un ct io n : Press the "Delay" and the "Start/Pause" buttons simultaneously for 3 seconds after
starting a program. It can no longer be changed by operating buttons or knobs. The washing machine emits an audible
signal while the control panel is locked. To unlock press the "Delay" and "Start/Pause" buttons again for 3 seconds.
¬ Power-off memory function: In case of abrupt power failure or the need to cut off the power during a program
cycle, the present settings will be saved and the preset operation will resume when the power is on again.