1.Preparation before washing
Preparation before washing
1.Connect the water inlet hose
2.Confirm that the washing machine is earthed reliably. Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe.
3.Put down the drain hose
2.Put in the laundries
The capacity of washing of the machine refer to the largest weight of the standard laundries under dry condition that can be washed in one time. Laundries quantity in one washing cycle shall be lower than the rated capacity.
The thickness ,size , type of the cloth will influence the actual washing capacity. It is suitable to put in reasonable amount of laundries and the laundries can be turned round in washing for one time washing.
4.Slanting or uneven ground may result in unstable working or abnormal noise. Please make the machine stand horizontally.
3. Usage of detergent
Control panel seat
Washing powder inlet
Liquid detergent inlet
Softener inlet
Add washing powder and softener into the box directly as per indicated in left figure
After adding, close the box.
Pay attention to followings before washing the laundries
Washing powder box
How to use washing powder
Confirm if there's special requirement for the laundries.
Clear the pocket. Take out the coins , sand, hairpins etc.
Fasten the buttons and zippers.
The quantity of the laundries shall not exceed the rated value. The big laundries like the jeans shall be put in loosely.
When the pulsator is running ,the buttons of the laundries may cause noise. For the sake of discretion ,please put the laundries with buttons into other laundries.
How to use softener
See to the manual of softener for the usage and dosage. When adding softener into the softener inlet of washing powder box, note that it shall not exceed the lower side of the cap.
Do not leave the softener for long period after adding it
into the box. Otherwise it may be solidified and block the inlet. As the softener is easy to solidify, please clean the box frequently.(You shall clean it each time you use reserve function).
Before use softener, you must select to sterilize function
How to use whitener
Add water to stipulated level. Dilute the whitener with container, and then pour it into the liquid whitener inlet slowly.
It is suggested to add washing powder into the box directly under fuzzy program and reserve program. Dissolve directly inside the washing machine: (not applicable for fuzzy and reserve program)
1.Add some water(select the "1" water level)
2.Add washing powder. Run for about 30s to fully dissolve
the Powder. Then push the"start/pause" button. 3.Put in laundries. Select suitable water level. Push the
"start/pause" button again. Quick dissolving of washing powder:
1.Prepare warm water of 30
C and container.
2.Add washing powder while stirring to dissolve it
completely.
Please add suitable washing powder as per the laundries quantity, the set water level and water quantity.
If you select save program, it is suggested to use liquid detergent instead of washing powder to guarantee the
a. Check if the laundries are applicable for washing with machine. b. Divide the laundries that are not colorfast from other laundries. c. Put those laundries difficult to absorb water into water with hand.
d. For those laundries with heavy soil, please first remove the dirt like mud or dust. For the parts with heavy soil, please apply detergent in advance, which can make it easier to remove the soil.
Laundries with color or pattern is not colorfast, thus not applicable. The whitener shall not touch laundries directly.
See to the manual of whitener for the usage and dosage. For whitener in powder, dissolve it before use.
washing effect.
It is not recommended to use
e. For those laundries that may get lint ball and those with long fur, turn it over before putting in. f. Do not put those laundries polluted by chemicals directly into the washing machine.
For those small laundries and those may get twisting or worn, and woolen/fur laundries, please put them into mesh bag for washing.
4. Close the top lid
If you open the top lid,the machine will stop working and alarm in spinning process.
