Haier HWM88-0566T user manual Install the water inlet hose, Confirm the water faucet

Install the water inlet hose

Confirm the water faucet

Water faucet,suitable	Water faucet,not suitable
Outlet end surface
>10mm

It is required that the front end shall be longer than 10mm.

The exit end face of the faucet shall be flat and smooth. If not please file it to avoid leakage.

"Start/pause" button

After the power is switched on, press it to start the machine

During working, push it to pause. During pause, push this button to restart and go on working

"Power" button

Push the "power" button to switch on the power.

Under power-on mode, push it to switch off the power. Push the "power" button to switch on the power. If the "start/pause" button is not pushed, the machine will switch off the power automatically after 5 minutes.

Connection between the water inlet hose jointer and the water faucet

1.Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from the water inlet hose component. See to Figure 1.

2.Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet hose on the faucet. See to Figure 2. (If the faucet is too large and the jointer can not be set on the water faucet, please loosen the four screws and take out the bushing in the jointer. The front end of the faucet must be smooth,

otherwise it may leak water. See to Figure 3.)

STANDARD	COTTON
BLANKET
	1HOUR

SAVE 2HOURS

SILK

PROGRAM AIR DRY

ER

POW FF

ON/O

START

USE

PA

water inlet hose jointer

Slider

Screw

Sign plate

Lock level

Screw knife

Bushing

water inlet hose

Figure 1

Figure 2 Figure 3

"Program" button

"AIR-DRY"button

3.Fasten the four screws evenly. See to Figure 4.

4.Take off the nameplate. Twist the fastening nut as per the indication of the figure to seal up the exit end face of the faucet. See to Figure 5.

remark: Before installation, the threading is 4mmabove the upper surface of the nut.

After installation, the threading is 2mm above the upper surface of the nut. See to figure 6.

About 4mm before twisting

About less than 2mm after twisting

Screw nut

Figure 4 Figure 5 Figure 6

Following full-auto program is available
Program	Application
Standard	Common washing
Blanket	Washing for coverlet, bigger ,heavy
	thickness laundries
Save	Washing for the normal laundries
	in short time
Silk	Washing for silk textiles
Cotton	Washing for cotton textiles

Push the "AIR-DRY"button ,then the "AIR-DRY" indicator light is on, that means the "AIR-DRY" program is chosen. The purpose is drying the inner tub and the outer tub, which can avoid growing mildew on the outer tub and the inner tub.