Fujitsu Siemens Computers FPCPR25 manual Installing the System into the Mini-Dock, C A U T I O N S

minidock.fm Page 6 Tuesday, August 21, 2001 3:30 PM

Installing the System into the Mini-Dock

C A U T I O N S

■Dropping conductive material onto the charging contacts could result in internal damage to the pen tablet circuitry.

■Prior to installing your pen tablet into the mini-dock, be sure to power down your system first. Failure to do so could result in damage to the system or mini-dock.

1.Shut down the system by selecting Start> Shut Down> Shut Down.

2.If a wireless module is installed in your system, remove the right-hand support to accommodate the extra depth (see Figure 4). To remove the support, slide it upwards until it unlatches from the support platform.

3.Position the pen tablet against the positioning guide and the back of the mini-dock.

4.Slide the pen tablet into the tray at the bottom of the mini-dock and press it down firmly until it is seated, as shown in Figure 4. The alignment guide in the bottom of the tray ensures that the system is properly seated over the connector.

5.Re-start your system.

6