Haier LE32F600, LE32A650 Getting Started, Preparing Your Remote Control, Installing the Batteries

Note

• The initial setup process may vary depending on different systems. Follow the on-screen instructions to complete the setup.

LED Backlit Flat TV Instruction Manual EN-9

The channel tuning starts. Wait a few minutes for the tuning to complete.

Press S/T/W/X to highlight your OSD language, then press OK.

Press opens.

to turn on the TV. The setup wizard screen

2.

3.

4.

5. When the tuning is finished, the TV will tune to the first channel stored on the channel list.

Make sure that you have:

• Installed the remote control batteries. (See page 9 for details)

• Connected an antenna or cable TV. (See page 7 for details)

• Connected the power cord on the back of the TV to a working power outlet.

For LE32F600, connect the supplied power cord to the AC IN jack on the back of the TV and to a working power outlet.

1.

Getting Started

Initial Setup

The first time you turn on your TV, the setup wizard guides you through setting up basic settings including the menu language and auto tuning.

Getting Started

Preparing Your Remote Control

Installing the Batteries

1.Open the battery cover.

2.Install two AAA batteries. Make sure that you match the + and – symbols on the batteries with the + and – symbols in the battery compartment.

3.Replace the battery cover.

Remote Control and Battery Cautions

•Ensure that there is nothing between the remote control and the remote sensor of the TV set.

•Use the remote control carefully. Do not drop the remote control on the floor.

•Sunlight, or other strong light, will interfere with the signal from the remote control. Avoid using near fluorescent lights or neon signs.

•Do not place the remote control in direct heat or in a damp place as you may damage the remote.

•Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. The batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.

•If your TV is not to be used for a long period of time, remove the batteries from the remote control.

•Do not dispose of the batteries with standard household waste. Do not throw them in a fire. Dispose of the battery according to local regulations.

EN